User manual Samsung Bio Compact S821

User manual Samsung Bio Compact S821
CONTENT

Samsung washing machines are very popular in Russia. Their advantages include stylish design, the use of innovative technologies, as well as a large number of models.

This article contains brief instructions for the Samsung Bio Compact S821 washing machine, which will help you understand the new equipment.

Installation recommendations

This model is an ideal home appliance that will be able to improve order in your home, ridding you of dirt and stains on things. But first you need to install and learn how to use it according to the instructions.

Samsung Bio Compact S821

The packaging and documentation supplied with the machine must be kept until the warranty period expires.

First you need to unpack your Samsung washing equipment and carefully inspect it. There should be no mechanical damage to the device.

Then you need to unscrew the transport fasteners. They are located on the rear wall of the unit.

Next you need to decide on the installation location. You need to take care of this in advance, even before purchasing a washing machine. It is necessary to strengthen the floor and install all communications. Move the furniture so that there is a small gap between it and the washing machine body.

After completing the above work, you can connect the washing equipment.

Here are some tips for installing your washer:

  • Try to level the body of the device as much as possible.To do this, you need to twist its legs one by one using a wrench.
  • When connecting the inlet hose, rubber O-rings must be installed. When stored for a long time they become hard. In this case, they need to be soaked in liquid machine oil.
  • The inlet hose may be too short. In this case, instead of the standard one, you need to buy and install a longer hose. It is not recommended to extend the standard hose.
  • When connecting the drain hose either to a siphon or to a sewer pipe, it is necessary to seal the connection. And you need to strengthen it with a clamp, because when the water is drained by the pump, high pressure is created and in the place of a bad connection, water can splash out onto the floor.
  • You can do without connecting the drain hose by throwing it into the bathtub or hooking it over the side of the sink. However, this is not the most aesthetic way.
  • To use the washing machine, you must install a separate moisture-resistant socket. In case of power outages, it is necessary to connect a voltage stabilizer.

 

 

Purpose of control buttons

After connecting the washing equipment, familiarize yourself with its capabilities. Carefully study the control panel, reassignment of all buttons and other elements that are on it.

Samsung Bio Compact S821 contains the following parts:

Samsung Bio Compact S821 control panel

  • Powder dispenser. This most important element is located to the left of the control panel. It is in it that the washing powder is poured, as well as bleach and, if necessary, conditioner.
  • Indicator panel. Represents many light bulbs. Each indicator has its own purpose. With their help, the user learns various information about the washing process, rinsing and spinning.They also indicate to the owner what exactly is wrong with the washing equipment.
  • Button for selecting washing programs. This is the first button from the tray with cells. Using this button, you scroll through the programs to select the one you need.
  • Button for selecting temperature. This is the second button from the detergent tray. Allows you to change the water temperature.
  • The third button is "drum revolutions". It is used to set the spin speed of the laundry. You can set the mode without spin, as well as the speed of six hundred and eight hundred revolutions.
  • The fourth “start” button from the tray. When you press it, the selected washing program starts. It is also pressed if you need to stop the washing process.
  • On/Off button. Located on the right edge. The purpose of this button is clear without comment.

Laundry

After carefully studying the control panel, you can start the first wash process. According to the instructions, the very first wash should be done with an empty drum. In other words, you cannot put things in the machine. This is necessary to wash the internal parts of the device.

The launch is carried out as follows:

washing clothes in an automatic washing machine

  • Connect the unit to the electrical network;
  • Place some laundry detergent in the left compartment of the powder receptacle.
  • Open the taps through which water enters the machine;
  • Set the water temperature to 40°WITH;
  • Press start;
  • Wait until the washing program has finished.
Every machine owner should know how to properly place laundry detergents in the powder receptacle. When prewashing, use the right compartment. The air conditioner is poured only into the middle cell. The left cell is the most commonly used. It is used during the main wash.

Let's figure out how to start the washing machine for everyday laundry.

  1. Turn on the device;
  2. Open the hatch door;
  3. Place dirty laundry inside. All dirty items must be sorted before washing. The laundry should not be placed in a lump;
  4. Close the door. There should be a characteristic click;
  5. Place conditioner and detergent into the powder receptacle;
  6. Using the buttons on the control panel, select the washing program, water temperature, and spin speed;
  7. Press the “start” button.

 

Proper care of equipment

Samsung Bio Compact S821 washing equipment does not require special care. The actions that need to be performed after the next wash are unlikely to create great difficulties. It is important to follow basic rules for caring for equipment. This will avoid problems with the washing machine in the future.

The following rules must be followed:

Samsung Bio Compact S821 powder receptacle

  • The Samsung washing machine must be dried after each wash. All wet parts of the machine, including the hatch cuff, should be wiped with a rag. The powder receptacle and hatch should remain slightly open after washing. This is necessary for the water to evaporate. Then fungus will not appear in them.
  • The control panel must not be exposed to water or detergents. If this happens, it needs to be wiped with a dry cloth. Water has a negative effect on electronics.
  • The debris filter should be cleaned twice a year. It is necessary to unscrew the filter plug and drain the water. Then clean the filter from dirt and debris.
  • Clean the machine's filler filter annually. It is located in the place where the inlet hose and the body of the device are connected.
  • Inspect the inlet hose regularly. If cracks or other damage appears on it, it must be replaced to prevent leakage.

This is interesting
  1. Vasil
    Answer

    Thanks for the info! Sincerely, Vasil.

  2. Ziliya
    Answer

    My machine fills with water and stops. What to do?