Owners of washing machines are often faced with a situation where they need to restart the washing machine. For example, when the light goes out, the program running fails, or the user selects a mode that is not suitable for this type of laundry. There may also be cases when it is necessary to put or remove an item from the drum that got there by mistake. Next, we’ll figure out how to restart the washing machine.
In what cases is it necessary to restart the machine?
In what follows, the word “reboot” only means restarting the program.
It may be required in the following situations:
- when there is a foreign object in the washing machine. Washing machine owners often forget small items or documents in their pockets. In this situation, it is recommended to quickly stop the machine and then restart the program;
- when you need to put something into the typewriter;
- if it is necessary to change an already running program;
- A program restart is also required when the laundry process is stopped due to a power outage. It should be noted that some machines continue the interrupted wash after turning on the power. In this situation, a reboot is not required;
- when the program freezes. A reboot may be necessary when the machine does not respond to signals or stops washing or spinning clothes.
How to properly reboot the machine
Washing equipment can be rebooted using the special “Reset” button. However, most washing machines do not have this button. In this case, the program launch button functions as a reset button.
It is important to note that restarting the washing machine can be done differently depending on the model. Therefore, it is recommended to always read the instructions before any action.
To change the mode, you must perform the following steps:
- Press and hold the program start button for 3-5 seconds;
- Wait until the washing mashine stops. It is important to note that some washing machine models drain the water before stopping.
- Select the appropriate mode;
- Add detergent to special compartment, if necessary;
- Start the wash by pressing the appropriate button.
You can do this in the following ways:
- Using a special hose located next to the drainage filter;
- Through drain filter;
- By selecting the spin mode while the “No spin” function is running. The steel machine will drain the water in a few minutes, after which it will stop and its door will unlock.
If you drained the water yourself, then it is recommended to turn off the washing machine. To do this, press the power button and then unplug the cord from the outlet. After 5-10 minutes, the washing machine door will unlock and it will open. Next, put or remove the desired item and start the washing machine in the usual way.
When restarting your washing equipment, it is important to first turn it off and only then unplug the power cord. Otherwise, the machine may become blocked or the system board may malfunction. Repairing the latter will be quite expensive.
When there is a power outage, you must unplug the power cord from the outlet. The fact is that when electricity is supplied, a voltage surge may occur. Therefore, by disconnecting the washing equipment from the power supply, we will prevent the control board from burning out. When power is available, the machine can be turned on again. The machine will continue washing if the program has not been automatically reset. Sometimes the machine drains liquid when turned on and stops.
However, this method should not be used constantly. In such a situation, you need to contact a specialist. He will be able to identify and eliminate the problem that has arisen.
