Error E23 in a Bosch washing machine is quite common. It appears on the display when the leakage protection sensor is triggered. Will try to figure out what to do when this error occurs.
Causes of leakage
This error on a Bosch washing machine is deciphered in almost the same way as error F23. It notifies the owner of the equipment that the sensor of the system providing protection against leaks has been activated. This sensor is located in the pan of the machine.
Principle of operation Aquastop sensor simple enough. There is a special segment in the washer tray that is connected to a float. When water enters the pan, the float begins to rise. As a result, the sensor is triggered, and then error code E23 appears on the machine display.
There are a number of reasons why a leak can occur:
- A hole appeared in the tank of the car;
- A crack has formed in the drain pipe;
- Inlet hose leaking. Perhaps this hose was not screwed on properly;
- Powder receiver leaking. Either it is simply not inserted;
Aquastop sensor dysfunction
Experts recommend checking the pan before installing the Aquastop system. There should be no debris in it. Small debris can get on the float, causing it to rise.
Debris in the pan may cause the sensor to not work if a real leak occurs.
It should be noted that the Aquastop sensor is very sensitive. Error E23 may appear even if you move it carelessly or installation of washing equipment.
How to troubleshoot a problem
If error E23 appears due to the accumulation of water in the washer tray, then you need to immediately look for the cause of the leak. On the Internet you can find different ways to solve this problem. Some suggest tilting the body of the washing machine so that the float lowers. Others advise pumping out the water using an enema bulb. However, all these measures give only temporary results.
If the cause of the leak is not eliminated, water will accumulate again after some time and will need to be pumped out.
It is necessary to partially disassemble the Bosch machine and check the tightness of the following parts:
- Hoses and their connections;
- Branch pipes and their connections;
- Tank;
- pump;
- Dispenser.
Often craftsmen replace a broken part completely. However, in some situations it makes more sense to repair the faulty element, such as when the crack in the tank is small. And replacing a faulty tank with a new one is a labor-intensive and expensive process.
If the cause of error E23 lies in the Aquastop sensor, then it must be replaced with a new one. To do this, you need to unscrew the pan and carefully remove it without tearing off the wire. Next you need to disconnect the wire from the sensor.Then you should pry the Aquastop sensor with a screwdriver and pull it out of the latches. Replace it with a new sensor.
