Error F16 in a Bosch washing machine is one of the most obvious. Usually, the user understands the reason for this error even without decoding the code. It occurs when the hatch door does not close. Next, we will find out how to fix this error.
Causes
Code F16, which appeared on the display of a Bosch washing machine indicates that the equipment has problems associated with closing the door. This error will appear when you close the door of the washing machine and start the wash.
As a rule, the F16 code appears on the display after selecting the desired washing program. Error F16 very rarely appears during or at the final stage of washing.
If Bosch washing equipment has a display , then there should be no difficulties at all.
After all, you will see the error code F16 and will be able to quickly decipher it. Next, determine the possible breakdowns that led to the error and look for a specific malfunction.
This picture shows the control panel of a Bosch machine that does not have a display. The washing machine displays error F16. There are no lights on the panel, only the LED located opposite the number 1000 is blinking.
In Bosch machines with a slower spin, the F16 error may be signaled by the light located opposite the number 800.
Also, code F16 may occur with the following malfunctions:
• The hatch locking device is broken or de-energized;
• The hatch locking mechanism is out of order;
• Some object prevents the hatch from closing;
• The contacts between the control module and the UBL are burned out or the wiring is faulty;
• The control module of the Bosch washing machine is broken.
UBL malfunction
Let's check first hatch locking device Bosch washing machines. First of all, disconnect the machine from the power supply.
Then you need to open the door as wide as possible and inspect the locking mechanism of the machine hatch. There is a possibility that the cause of the malfunction is not the hatch locking device, but the locking mechanism. The latter includes a spring and a special hook. You need to check the integrity of the spring, and then inspect the locking hook. It should not be moved to the side.
If the locking mechanism is in good condition, then you need to check the hatch locking device. You need to find a small hole located to the left of the hatch of the Bosch machine. There are two fasteners on the sides. These fasteners must be unscrewed.
After unscrewing the screws, you need to tilt the Bosch machine back a little. Next, you need to push the cuff away with your fingers, stick your hand in and find it by touch. UBL. Then you need to feel with your fingers the chip with the wires that are connected to this part. This chip must be carefully disconnected. After completing this work, you can safely take out the UBL.
Then you need to test the UBL. This is done using a multimeter.The old faulty device should be replaced with a new, similar one. It is important not to forget about connecting the power supply.
Faulty wiring and control module
It is possible that the hatch locking mechanism is working properly, but code F16 still appears on the display of Bosch equipment. Then you need to check the wires between the control module and the UBL.
To perform this work, it is necessary that the wiring of the interlock device be freely accessible. This is achieved by removing the rubber cuff.
After gaining access to the wiring, you need to check it for breaks. It is also necessary to check and clean the contacts. If after this the malfunction does not manifest itself, then it is likely electronic module is the culprit for error F16.
You only need to check and repair the control module of a Bosch unit yourself if you have the appropriate knowledge and experience. The best solution is to entrust this work to a specialist. Then you will be able to avoid unnecessary waste of money and time.
