Error E17 in Bosch washing machine occurs when water does not enter the tank. In this case, the equipment refuses to carry out any washing program. Let's figure out why this error occurs and how to fix it.
Causes
As mentioned above, code E17 in Bosch washing equipment indicates that water is not entering the tank. Therefore, the washing process may not start. For some washing machine models, this malfunction corresponds to error F17. This is what the manufacturer intended.
If the Bosch washing machine does not contain a display, then this error can be determined by two indicators that are lit: rinse and spin at 1000 rpm. However, deciphering the E17 code is not enough. You should find out why the error occurred.
There are several of them:
- The filling valve has failed;
- Broken pressure switch;
- The control module has failed;
- Damage to the wiring between the above elements.
But when looking for the cause, you should first check the simplest options. First you need to check if there is water in the tap. Perhaps it is missing. You should also check the water supply tap. It is located in the place where the inlet hose is connected to the water supply.
Fill valve problems
If everything is in order with the water supply, then to eliminate the problem it is necessary to consistently check the parts of the washing machine.First you need to disconnect the washing machine from the power supply. Then turn off the water supply, and dismantle the inlet hose. Behind the hose is the fill valve filter.
Perhaps it is clogged. It needs to be washed with a stream of water and then installed in its place. Next, you should check the valve itself.
This is done as follows:
- Rent to Bosch washing machine top cover;
- Measure the valve coil resistance using a multimeter;
- Check the wires of the part, as well as their contacts.
If a part fails, it must be replaced with a new one. To do this, you will need to disconnect the wires and all tubes secured with clamps. When purchasing a new filling valve, it is important not to forget to purchase new clamps with which to connect the pipes.
If error E17 in a Bosch washing mashine did not occur due to this part, then you need to check next water level sensor. This element is located in the right corner of the washing mashine. It is necessary to inspect the tube and contacts of the connected wiring. Next you need to inspect the pressure switch itself. The faulty element should be replaced with a new one.
Control module failure
It is better to entrust repair of the control module to a specialist. Especially if you have not previously dealt with repairing complex electronics. This part is quite expensive, so it's better not to take risks.
So, code E17 on Bosch washing mashine may appear for various reasons.
Simple ones can be completely eliminated on your own. And if complex malfunctions occur, such as a breakdown of the electronic module of a Bosch machine, it is better to contact specialists.
First, check the fine filter (mesh), which is installed in the hose on the side of the water supply tap. The mesh can easily become clogged even in urban water supply conditions.