When your Indesit washing machine displays error code f11, it thus warns that there are difficulties draining liquid from the tank. In most cases, this malfunction is explained by a clogged filter. In addition, there are a number of probable reasons why waste water is not drained into the sewer system - pump failure, failure of the pressure switch or control module.
The problem may be hidden not only in these elements, but also in their components - hoses, wiring, pipes, etc.
What to do first?
We already know what error f11 means. It remains to figure out how to deal with the problem.
Error code f11 may appear on the washing machine screen at startup or during operation. The unit suddenly stops draining water, spinning things out, and stops the activated cycle.
Filter check
This element is the main cause of error f11 on the Indesit SMA. Small objects and other debris constantly accumulate in it. All this is carefully removed so as not to damage filter system.
The algorithm of actions is as follows:
- the Indesit washing machine is disconnected from the electrical network, water supply and sewerage;
- there is a filter. As a rule, it is located below behind the decorative panel, which must be removed;
- spread rags near the Indesit washing machine and unscrew the filter;
- We clean the element, for which you can use an old toothbrush. To remove accumulated scale, the filter can be soaked in a solution of citric acid;
- the part is washed with running water.
Checking all drainage elements washing machine Indesit, after which you can install the filter in place, screwing it tightly so that the lid fits against the unit, eliminating leakage.
Checking the pump
Have you checked the filter and still get error f11? Don't know how to fix the problem? We recommend checking the pump - the second likely source of the problem. First, unscrew the fasteners, remove the bottom, disconnect the wiring, loosen the clamps, remove the pump from the washing machine.
After this, the following actions are performed:
- the pipe is cleaned;
- the pump impeller is inspected and all debris is removed;
- Having remembered the location of the wires, turn off all the chips and the drain hose, turn the pump housing against the clock hand half a turn;
- after this, the latches are pryed off, the cover is removed, the mechanism is completely inspected, the sealing elements and the impeller are checked. Everything must be thoroughly cleaned and the pump installed in its place;
- Using a multimeter, the pump is “ringed” to ensure its integrity. If the device screen displays less than “1”, the pump is burnt out, and it is best to replace it with a new analogue.The three-digit number that appears forces you to continue searching for the problem in order to eliminate error f11 on the Indesit washing machine;
- We lay the washing mashine on its side and use our hands to feel all the hoses connecting the pump to the tank. Occasionally small things end up inside them. If this is suspected, the hose should be disconnected from the pump and cleaned.
- Remember that all repair and maintenance work ends with a control check washing machine Indesit check for signal f 11 to disappear. To do this, the washing machine starts so that you can verify its operation.
Conclusion
If you have cleaned the filter and pump, but the Indesit washing machine still displays error f11, pay attention to the control board triac and the sensor that monitors the liquid level.
