Today, 8 out of 10 owners of automatic washing machines do not even know about the need to periodically clean the rubber seal. The fact is that rubber cuffs retain residual moisture after washing. As a result, black mold spots form, emitting an unpleasant smell of rot. In this article you will learn how to clean an elastic band in an automatic washing machine.
Caring for the rubber cuff is a necessity
To avoid this and extend the service life of the rubber sealing cuff, it requires constant care. If you leave the washing machine door open for a while after each wash and dry the elastic with a dry cloth, these problems will not occur at all, and you will not have to clean the elastic. If the rule has been ignored for many years, there is a growing need for urgent cleaning.
Let's figure out together how to properly clean gum in the washing machine machine.
In practice, various proven means are used:
- remove mold using a set of chlorine-based cleaning liquids - “Domestos”, “Toilet duckling”, “Whiteness”; You can clean the sealing gum with a solution of copper sulfate or nail polish remover;
- For scale, citric acid, white vinegar, or the special anti-scale product intended for this purpose are best suited.
Practical tips for combating mold
Now let's figure out what needs to be done practically. The edges of the elastic must be bent to wipe the inner layer, where, in fact, fungal mold appears. The sponge is moistened with “Whiteness” or another product containing chlorine. Together with the rubber band (special attention to the grooves of the rubber band, more substance is applied to them), the surface of the drum of the washing machine is also wiped. Then it is closed. After half an hour of such disinfection, the “rinse” mode starts so that the internal parts of the washing machine are thoroughly washed.
You can also clean the cuff of the washing machine with dissolved copper sulfate (diluted with water in a ratio of 30 g per 1 liter). It is moistened with a solution, and after a day it is washed off with water and thoroughly wiped with a dry cloth.
Descaling options
The content of mineral impurities in tap water contributes to the formation of scale that settles on the gum. In this case, the machine can be cleaned using water softener means "Calgon".
Not everyone knows that the porous structure of scale is a favorable environment for mold growth. The use of some folk remedies helps eliminate plaque.
There are three options:
- You need to pour 100-200 g of citric acid into the drum (depending on the intensity of the scale) and turn on the longest program, heating the water to 60 degrees.Then you should additionally set the “rinse” mode and better wash away the remaining scale. Finally, be sure to wipe the cuff dry.
- Instead of citric acid, take 1 liter. white 9% vinegar, but many are annoyed by the unpleasant vinegar smell remaining after washing with this product.
- Antiscale is also effective in combating scale formation on the cuff. Instructions for using it are on the branded packaging of the product.
Prevention measures
Many owners install a special hood in the bathroom to remove excess moisture and steam. It’s a good idea to have an ultraviolet lamp for prevention, turning it on in the bathroom once a week for 15 minutes.
Experts advise removing the powder tray from the machine at the same time. It is important to periodically get rid of its residue by thoroughly rinsing the tray with plenty of running water.
We hope that readers have made up their minds and will now monitor both the appearance of the washing machine and its internal cleanliness. How to properly clean sealing gum They will tell their friends too.
